Powering On Dichroic Theatre Units - High End Systems Dichroic Theatre Series User Manual

Dichroic theatre series

Hide thumbs

Table Of Contents

Table of Contents

•

Verify the truss or support will handle the combined weight of all the devices on

the truss.

•

High End Systems strongly recommends using safety cables to attach any of its

fixtures to a truss. Safety cables are provided with the ColorPower supply. If

necessary, you can order additional safety cables from your High End Systems

dealer/distributor (see "Optional Accessories" on page 1-7).

•

You must supply your own clamps to attach the Color Power supply to the

support. Verify that the clamp(s) you use are capable of supporting the weight of

the unit. Each ColorPower supply weighs 13 lbs (5.9 kg). You can order

cheeseboroughs for a two-inch truss from your High End Systems dealer/

distributor (see "Optional Accessories" on page 1-7).

•

Make sure the ColorPower supply and attached fixtures cannot be rotated all the

way around (360

mounting bolts.

Note: Because of the variety of conceivable lighting designs, you should consider the

procedure below as a suggested guideline only. High End Systems, Inc. cannot

make specific recommendations for your particular lighting design or venue.

To mount the ColorPower supply to a truss or another type of support:

•

Attach a suitable clamp through the handle.

•

Always stand on a firm, stable surface when mounting a fixture to its support.

The fixture should be at a height where you can comfortably work on it, and

should either be resting on a stable surface or held in a stable manner.

•

Tighten the clamp(s) firmly to the yoke and to the support.

•

Loop one or more suitable safety cables around the support and through the

handle.

Caution:

After mounting the fixtures, inspect all connected cables to

ensure that the cables are properly routed away from any hot

surface.

Do not mount ColorPower above or next to a hot fixture closer

than 1 ft (.3 m).