Table of Contents
Advertisement
Appendix B:
ColorCommand Installation
ColorCommand Setup
The ColorCommand fixture ships with the following items:
•
ColorCommand fixture (with attached yoke)
•
One power cord (without a cord cap)
•
Declaration of Conformity
Installing the Lamp
The ColorCommand fixture ships without a lamp. Use the following procedure to install
a lamp in a new fixture. or to replace a lamp.
Warnings: Disconnect power before lamping or servicing.
An operating, unshielded lamp emits ultraviolet and visible (UV-vis)
radiation which could damage eyes and skin. Whenever you are
working on or near an exposed lamp, wear protective eye gear. Never
look directly at the lamp while the lamp is on.
Hot lamp. Let the lamp cool before replacing.
Caution:
This equipment is designed for use with a Philips® Halogen Biplanar
lamp only. Using any other type lamp may be hazardous and will void
the warranty.
Disconnect power before re-lamping. Replace the lamp if it becomes
damaged or thermally deformed.
To install a lamp in a new fixture, or replace a
lamp in an existing fixture:
1. Perform this procedure before you connect
the fixture to power.
2. Put on protective eye wear and gloves.
3. Access the lamp cap on the rear lamp socket
housing and loosen the two thumbscrews.
4. Gently remove the socket housing from the
reflector mount, exposing the lamp as shown
in Figure B-1.
5. Remove the lamp from the socket housing.
Dichroic Theatre ™ User Manual
Figure B-1 Removing the lamp
ColorCommand Installation
B
B-1
Advertisement
Table of Contents
