Table of Contents
Advertisement
9 Setup of Traffic Management System
The Raven Traffic Management System differs from the Raven Navigation Aid System in that it uses a
WAAS GPS receiver. This WAAS GPS receiver is a low-end, third-party, GPS receiver.
This system contains a third-party Bluetooth GPS receiver, a Raven BPI (Bluetooth Pilot Interface), and a
laptop computer. The GPS receiver is for use only when the AIS GPS is not available, and does not
provide the same accuracy as the sub-meter Raven GPS receivers.
Figure 14: Raven Traffic Management System
To use the iBlue 737 with the Raven Traffic Management System, do the following:
9.1
General Setup Steps
In general, the steps are:
1. Set up the computer and turn it on. You may apply 100-240 VAC power or use the internal laptop
battery.
2. Set up the GPS receiver as described in the next sub-section, 'Setup of Traffic Management GPS
Receiver'.
3. Setup the BPI, as described earlier in this document.
4. On the laptop computer, start the Raven navigation software, usually Wheelhouse II (WHII).
Navigation Aid System Setup and Operation Manual
Page 16 of 21
Advertisement
Table of Contents
