Table of Contents
Advertisement
7 Setup of 210LB Navigation Aid System
This system contains a 210LB (Bluetooth) GPS receiver, a Raven BPI (Bluetooth Pilot Interface), a TBA-
2 antenna, 50 feet of antenna cable, cable reel, antenna clamp or magnet, and a laptop computer.
Figure 9: 210LB Navigation Aid System
7.1
Setup Steps
In general, the steps are:
1. Set up the computer and turn it on. You may apply 100-240 VAC power or use the internal laptop
battery.
2. Set up the antenna, as described earlier in this manual.
3. Connect antenna cable to DGPS unit. Connecting the antenna to the DGPS before applying
power ensures that the DGPS unit provides a position in the shortest possible time. If you have
turned the DGPS unit on without an antenna, turn it off for 10 seconds, connect the antenna, and
then turn it back on.
4. Plug in the DGPS to 100-240 VAC, unless it is the 210LB/Battery unit, which is battery-operated.
5. Setup the BPI as described earlier in this manual.
6. On the laptop computer, start the Raven navigation software, usually Wheelhouse II (WHII).
Navigation Aid System Setup and Operation Manual
Page 11 of 21
Advertisement
Table of Contents
