Setup Of 210Lb/Battery Navigation Aid System; Setup Steps - Raven 210LB Setup And Operation Manual

8 Setup of 210LB/Battery Navigation Aid System

This system contains a 210LB/Battery GPS receiver, a Raven BPI (Bluetooth Pilot Interface), a TBA-2
antenna, 6 feet of antenna cable, antenna clamp or magnet, and a laptop computer.
Figure 10: 210LB/Battery Navigation Aid System
8.1

Setup Steps

In general, the steps are:
1. Set up the computer and turn it on. You may apply 100-240 VAC power or use the internal laptop
battery.
2. Connect the antenna cable to the antenna input. Do not turn on the power yet. Connecting the
antenna to the DGPS before applying power ensures that the DGPS unit provides a position in
the shortest possible time. If you have turned the DGPS unit on without an antenna, turn it off for
10 seconds, connect the antenna, and then turn it back on.
Figure 11: DGPS Unit Connectors
Navigation Aid System Setup and Operation Manual
Page 13 of 21