Pack-Up Steps - Raven 210LB Setup And Operation Manual

7.2

Pack-Up Steps

Pack up the system in reverse set up order. It is very important that the power supply be unplugged
before any other wires are disconnected. In general:
1. Shut down the computer.
2. Unplug the computer.
3. Unplug the DGPS unit.
4. Disconnect the antenna cable(s).
5. Roll up the cable(s) and dismount the antenna(s).
6. Disconnect, turn off, and pack the BPI.
7. Do not store the computer in a very hot or cold location. Do not leave the computer in a car trunk
over night.
Navigation Aid System Setup and Operation Manual
Page 12 of 21