Installation
Instructions
[STEP 13] INSTALL SUPPLIED DUCT
COVER AND TOP COVER
Screws D
/
I
h st0,%ct
I I_
CoverScrew
n EachSide
• Install the supplied 2-piece duct cover over the
support frame (if using supplied frame). Snap ends
together.
• Secure duct covers to support frame with 2
Screws D.
• For a more finished appearance, a top cover is
supplied and should be installed whenever the top of
the hood is visible.
TIP: Place pieces
of tape over ends
of the cover to
prevent scatching
the duct cover.
Remove tape
before installing
screws.
• Engage tabs into slots on each side at the top of the
hood. The covers should lay flat in the impression on
top of the hood.
ScrewsC
over
Front and Back
• Install 2 Screws C to secure the cover to the hood at
the front and back.
ISTEP 141 FINALIZE INSTALLATION
• Check all lamps to assure tightness in sockets.
• Turn power on atthe circuit breaker.
• Refer to the Owner's Manual for operating and
cleaning instructions.
18