Step 4, Installsupport Frameand Ductcovers - Monogram ZV42I Installation Instructions Manual

Installation Instructions
TEP 41 INSTALL ACCESSORY (OR SUPPLIED) SUPPORT AND DUCT COV-
ERS
Install Small Pall Head
Screws on EachSide
Screws D
?
/
/ Install
Frametol I I II I InstallStop
Safety Screw Inst.al)ationl I I == I
on EachSide Screw
Screws E
Install supplied support
frame OR
telescoping
accessory frame
• Hang the supplied support frame or telescoping
accessory frame to the ceiling joists and cross framing
on the 4 hex head screws by engaging the keyhole slots
on the frame.
• Check to be sure the support frame is level, vertically
and horizontally.
• Tighten the hex head screws securely.
• Install safety screws, (Screws E) on each side of the
frame.
Adjust telescoping accessory frame to length
• Remove the 8 frame adjustment screws. Adjust the
lower support up or down to the pre-determined length.
Reinstall and securely tighten the 8 adjustment screws.
• Slide the top (inner) accessory duct cover up and over
the frame. Secure the duct cover to the frame as shown
using Screws D.
• Locate and remove the safety stop screw. Slide bottom
duct cover up and over the top duct cover. Align bottom
duct screw hole to the hole in the frame. Hold the duct
cover in place while installing screw.
/
) Screw
Storage Location
CAUTION:
The stop screw
must be installed. Failure to do so could result in
personal injury or damage to the duct cover. The stop
screw will prevent the lower duct from sliding down
while completing the installation.
PRUDENCE
II faat mettre en place la vis de but_e afin d'_viter des
blessures ou d'endommager I'enceinte du conduit. La vis
de but_e emp_che I'enceinte inf_rieure da conduit de
descendre pendant I'installation.
Secure house wiring
• Route house wiring through the ceiling and pull a length
to reach the hood junction box, approximately 6" below
the support. Tape to the right side of the support frame.
IMPORTANT: Again, check to be sure the support is
level in both directions. There is no way to level the hood
after the hood is secured to the frame.
14