Preparing The Opening - GE CP350 Installation Instructions Manual

Installation Instructions
PREPARING THE OPENING
rll The following MINIMUM clearance dimensions
must be maintained.
13" MAX. Depth of uprotected 1-1/2" MIN.
overhead cabinets Clearance from
cutout to side wall
on the right of the
unit
30" IV]IN.
Clearance from 15" MIN. Height
countertop to countertop to
unprotected nearest cabinet on
overhead either side of unit
surface
2" IV]IN. C learance
from cutout to side
wall on the left of
the unit
If a 30" clearance between the cooking surface
and overhead combustible materials or metal
cabinets cannot be maintained, o minimum
clearance of 24" is required and the underside
of the cabinets above the cooktop must be
protected with not less than 1/#' insulating
millboard covered with sheet metal not less than
0.0122" thick.
CUTOUT DIMENSIONS
OF THE COUNTERTOP
To insure accuracy, it is best to make a template
when cutting the opening in the counter.
th of cut
1-3//4 'l Min. Between _" cut
I_ " _1
cutout and the wall __ _ I
2-1/2 _Nin. III
from front edge
of cutout and
front edge of
countertop
JXTR32X CUTOUT FILLER TRIM KIT:
A filler trim kit is available for use if your countertop
cutout is larger than the dimensions shown, up to
29-13/16" x 20-7/16". O rder JXTR32X to reduce the
cutout opening for installation of this cooktop. This
kit may be ordered from your GE Dealer.
OVERALL COOKTOP DIMENSIONS
29-3/4"
__I
-_r r''" 21-3/8" (21-i/2" SS)
_._ -1/4" Front
4-5/8"
Rear
-"_ at the conduit
location
6-1/4" Bear
19-1/4" .._1_...... ._ on Model PP945
&PP950
B]
Five inches (5")
minimum vertical
clearance between
the cooktop bottom
and any combustible
surfaces.
l i
5"Min. I ' I_
Vertical Clearance
]
Make sure the wall coverings, countertop and
cabinets around the cooktop can withstand
heat (up to 200°F) generated by cooktop.
_cWaablil nCe_ sV e ar inndg '
countertop must
withstand heat up
to 200°F.