GE CP350 Installation Instructions Manual

30" electric cooktop

Advertisement

Available languages

Available languages

Quick Links

Installation
Instructions
30" Electric Cooktop
CP350, JP340, JP346, JP356, PP912, PP932, PP942,
PP944, PP945, PP950
I r_
,,if you have questions,
call 800.GE.CARES
or visit our website
at: ge.com"
I
BEFORE YOU BEGIN
Read these instructions completely
and carefully.
•IMPORTANT
- Save these
instructions
for local inspector's
use.
•IMPORTANT
- Observe
oli
governing
codes and ordinances.
• Note to Installer- Be sure to leavethese
instructions withthe Consumer.
• Note to Consumer - Keep these instructions for
future reference.
• Product failure due to improper
installation
is not
covered under the Warranty.
-_ WARNING - This
a ppliance
must be
properly grounded.
•ATTENTION
INSTALLER - ALL
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
"PLUG AND RECEPTACLE" IS NOT PERMITTED
ON THESE PRODUCTS.
• Proper installation
is the responsibility
of the
installer and product failure due to improper
installation
is NOT covered under warranty.
MATERIALS YOU
WILL NEED
Junction
Box
Wire Nuts
TOOLS YOU WILL NEED
_i
_,_
Pencil
Phillips Head
Screwdriver
Ruler or Straightedge
SaberSaw
1/8" Drill Bit & Electricor
Hand Drill
Safety Glasses
PARTS INCLUDED
4 Screws
(WBlXllS7)
Foam Tape
2 HoldDown
Brackets
31-10637-4
(11-1o GE)
1

Advertisement

Table of Contents
loading

Summary of Contents for GE CP350

  • Page 1 Installation 30" Electric Cooktop Instructions CP350, JP340, JP346, JP356, PP912, PP932, PP942, PP944, PP945, PP950 I r_ ,,if you have questions, call 800.GE.CARES or visit our website at: ge.com" MATERIALS YOU BEFORE YOU BEGIN WILL NEED Read these instructions completely and carefully.
  • Page 2: Important Safety Instructions

    Installation Instructions IMPORTANT SAFETY INSTRUCTIONS FOR YOUR SAFETY ELECTRICAL REQUIREMENTS • For Personal Safety, remove house fuse or open This appliance must be supplied with the proper circuit breaker before beginning installation. voltage and frequency, and connected to an Failure to do so could result in serious injury or individual, properly grounded branch circuit,...
  • Page 3: Pre-Installation

    Installation Instructions PRE-INSTALLATION CHECKLIST --&WAR NIN - The electrical power to Remove Installation Instructions from literature pack and read them carefully before the cooktop supply line must be shut off while you begin. connections (]re being made. Failure to do so could result in serious injury or death.
  • Page 4: Preparing The Opening

    24" is required and the underside cutout opening for installation of this cooktop. This of the cabinets above the cooktop must be kit may be ordered from your GE Dealer. protected with not less than 1/#' insulating millboard covered with sheet metal not less than 0.0122"...
  • Page 5: Installing The Cooktop

    Installation Instructions INSTALLING THE COOKTOP rim INSTALLING THE JUNCTION ATTACH FOAM TAPE Install an approved junction box where it will be Apply the foam tape around the outer edge of the easily reached through the front of the cabinet glass. Do not overlap the foam tape. where the cooktop will be located.
  • Page 6 Installation Instructions INSTALLING THE COOKTOP (CONT.) INSERT COOKTOP INTO CUTOUT 171 ATTACH HOLD DOWN BRACKETS TO CABINET Insert the cooktop centered into the cutout opening. Make sure the front edge of the Open the cabinet door and screw the hold down countertop is parallel to the cooktop.
  • Page 7 Installation Instructions INSTALLATION--ELECTRICAL CONNECTIONS When making the wire connections, use the once the connections are made, secure wires entire length of conduit provided. The conduit together using wire nuts. must not be shortened. With the cooktop in place, open the front of the cabinet door.
  • Page 8: Pre-Test Checklist

    Installation Instructions CHECKLISTS PRE-TEST CHECKLIST OPERATION CHECKLIST Remove oil protective film, if present, rand tony Remove oll items from the top of the cooktop stickers. surfmce. Check to be sure thot oll wiring is secure ond Turn on the power to the cooktop.(Refer not pinched or in contoct with moving ports.
  • Page 9 Instrucciones Estufa el ctrica de 30" de instalaci6n CP350, JP340, JP346, JP356, PP912, PP932, PP942, PPq44 PPq45 PPqSfl NECESITARA ANTES DE COMENZAR LOS SlGUIENTES MATERIALES Lea estas instrucciones por completo y con cuidado. • IMPORTANTE - Conserve estas instrucciones para el uso del inspector local.
  • Page 10: Instrucciones De Seguridad Importantes

    Instrucciones de instalaci6n INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD REQ)UISITOS ELI_CTRICOS • Para su seguridad personal, retire los fusibles de Este aparato debe contar con el voltaje y su hogar o bien abra el cortacircuitos antes de frecuencia adecuados, y deber6 conectarse a un circuito derivado...
  • Page 11 Instrucciones de instalaci6n LISTA DE VERIFICACI6N PREVIA A LA INSTALACI6N --AADVERTENCIA - Lo corriente Saque las instrucciones de instalaci6n del paquete de material impreso y 16alas el_ctrica a la tuberia de abastecimiento de la cuidadosamente antes de comenzar. estufe debe cortarse durante la realizaci6n conexiones.
  • Page 12 16minas met61icas de no la abertura cortada. Puede solicitar estejuego a su menos de 0.0122" de grosor. distribuidor de GE. DIMENSIONES Aseg0rese que los cubiertas de los paredes, el GENERALES DE LA ESTUFA mostrador y los gabinetes alrededor...
  • Page 13 Instrucciones de instalaci6n INSTALACI6N DE LA ESTUFA INSTALACI6N DE LA CAJA APLIQUE LA CINTA DE ESPUMA DE EMPALMES Aplique la cinta de espuma alrededor del borde externo del vidrio. No aplique un exceso de cinta Instale una caja de empalmes aprobada de espuma.
  • Page 14 Instrucciones de instalaci6n INSTALACI6N DE LA ESTUFA (CONT.) INSERTE LA ESTUFA EN SUJETE LAS ABRAZADERAS EL AREA CORTADA DE MONTAJE AL GABINETE Inserte la estufa centrada en el 6rea cortada. Abra la puerta del gabinete y atornille Aseg@ese de que el borde frontal del mostrador las abrazaderas de montaje a los lados est6 paralelo con respecto a la estufa.
  • Page 15 Instrucciones de instalaci6n INSTALACION--CONEXIONES ELI CTRICAS de cables, Una vez que se hayan realizado las FA1 Cuando realice las conexiones utilice toda la extensi6n del conducto incluido. conexiones, fije los cables con las tuercas El conducto no debe reducirse. para cables. Con la estufa colocada en su lugar, abra el frente de la puerta del gabinete.
  • Page 16 Instrucciones de instalaci6n LISTAS DE VERIFICACI6N LISTA DE VERIFICACI6N PREVIA LISTA DE VERIFICACI6N DE OPERACI6N Retire toda la pelicula protectora, si la hay, y las calcomanias. Retire todos los objetos que se encuentren sobre la superficie de la estufa. Verifique que todos los cables est#n fijos y que no est6n torcidos o en contacto con partes Encienda la toma de corriente...

This manual is also suitable for:

Jp340Pp912Jp346Pp932Jp356Pp942 ... Show all

Table of Contents