GE Caf�© CP350STSS Installation Instructions Manual
GE Caf�© CP350STSS Installation Instructions Manual

GE Caf�© CP350STSS Installation Instructions Manual

30” electric cooktop

Advertisement

Available languages

Available languages

Installation
Instructions
"If you have questions, call 800.GE.CARES or visit our website at: ge.com"
BEfORE YOU BEgIN
Read these instructions completely and carefully.
IMPORTANT
for local inspector's use.
IMPORTANT
codes and ordinances.
• Note to Installer – Be sure to leave these
instructions with the Consumer.
• Note to Consumer – Keep these instructions for
future reference.
• Product failure due to improper installation is not
covered under the Warranty.
WARNINg
properly grounded.
ATTENTION INSTALLER
COOKTOPS MUST BE HARD WIRED (DIRECT
WIRED) INTO AN APPROVED JUNCTION BOX. A
"PLUg AND RECEPTACLE" IS NOT PERMITTED
ON THESE PRODUCTS.
• Proper installation is the responsibility of the
installer and product failure due to improper
installation is NOT covered under warranty.
PARTS INCLUDED
4 Screws
Foam Tape
(WB1X1137)
31-10637-4
(11-10 GE)
— Save these instructions
— Observe all governing
— This appliance must be
— ALL
2 Hold Down
Brackets
30" Electric Cooktop
CP350, JP340, JP346, JP356, PP912, PP932, PP942,
PP944, PP945, PP950
MATERIALS YOU WILL NEED
Junction Box
TOOLS YOU WILL NEED
Phillips Head
Screwdriver
Ruler or Straightedge
Safety Glasses
1
Pencil
1/8" Drill Bit & Electric or
Wire Nuts
Saber Saw
Hand Drill

Advertisement

Table of Contents
loading

Summary of Contents for GE Caf�© CP350STSS

  • Page 1 Installation Instructions “If you have questions, call 800.GE.CARES or visit our website at: ge.com” BEfORE YOU BEgIN Read these instructions completely and carefully. IMPORTANT • — Save these instructions for local inspector’s use. IMPORTANT • — Observe all governing codes and ordinances.
  • Page 2: Important Safety Instructions

    If cabinet storage space is to be provided, the risk can be reduced by installing a range hood that projects horizontally a minimum of 5" beyond the bottom of the cabinets. Cabinet installation above the cooktop may be no deeper than 13".
  • Page 3: Pre-Installation Checklist

    PRE-INSTALLATION CHECKLIST WARNINg – The electrical power to the cooktop supply line must be shut off while connections are being made. failure to do so could result in serious injury or death. A When preparing cooktop opening, make sure the inside of the cabinet and the cooktop do not interfere with each other.
  • Page 4: Preparing The Opening

    29-13/16" x 20-7/16". O rder JXTR32X to reduce the cutout opening for installation of this cooktop. This kit may be ordered from your GE Dealer. Make sure the wall coverings, countertop and cabinets around the cooktop can withstand heat (up to 200°F) generated by cooktop.
  • Page 5: Installing The Cooktop

    INSTALLINg THE COOKTOP 1 INSTALLINg THE JUNCTION BOX Install an approved junction box where it will be easily reached through the front of the cabinet where the cooktop will be located. The cooktop conduit is 3 feet long. Install junction box so that it can be reached through the front of the cabinet.
  • Page 6: Insert Cooktop Into Cutout

    INSTALLINg THE COOKTOP 6 INSERT COOKTOP INTO CUTOUT Insert the cooktop centered into the cutout opening. Make sure the front edge of the countertop is parallel to the cooktop. Make final check that all required clearances are met. Cooktop Hold Down Bracket Installation Instructions (CONT.)
  • Page 7: Installation-Electrical Connections

    INSTALLATION—ELECTRICAL CONNECTIONS When making the wire connections, use the entire length of conduit provided. The conduit must not be shortened. With the cooktop in place, open the front of the cabinet door. Insert the wires from the conduit through the opening of the junction box.
  • Page 8: Pre-Test Checklist

    CHECKLISTS 1 PRE-TEST CHECKLIST Remove all protective film, if present, and any stickers. Check to be sure that all wiring is secure and not pinched or in contact with moving parts. Check level of appliance. D Check that the cooktop is properly grounded. Installation Instructions 2 OPERATION CHECKLIST Remove all items from the top of the cooktop...
  • Page 9: Instrucciones De Instalación

    Instrucciones de instalación “Si tiene alguna pregunta, llame al 800.GE.CARES o visite nuestro sitio Web en: ge.com” ANTES DE COMENZAR Lea estas instrucciones por completo y con cuidado. IMPORTANTE • — Conserve estas instrucciones para el uso del inspector local.
  • Page 10: Instrucciones De Seguridad Importantes

    Instrucciones de instalación INSTRUCCIONES DE SEGURIDAD IMPORTANTES PARA SU SEGURIDAD • Para su seguridad personal, retire los fusibles de su hogar o bien abra el cortacircuitos antes de comenzar con la instalación. El no hacerlo puede resultar en lesiones serias o incluso la muerte. •...
  • Page 11 Instrucciones de instalación LISTA DE VERIFICACIÓN PREVIA A LA INSTALACIÓN ADVERTENCIA – La corriente eléctrica a la tubería de abastecimiento de la estufa debe cortarse durante la realización de conexiones. El no hacerlo puede resultar en una lesión seria o la muerte. Cuando se prepare para la abertura de la estufa, asegúrese que el interior del gabinete y la estufa no interfieran uno con...
  • Page 12 29-13/16" x 20-7/16". Para poder instalar esta estufa, solicite el producto JXTR32. X para reducir la abertura cortada. Puede solicitar este juego a su distribuidor de GE. Asegúrese que las cubiertas de las paredes, el mostrador y los gabinetes alrededor de la estufa puedan soportar las temperaturas generadas por la estufa (hasta 200 °F).
  • Page 13: Instalación De La Estufa

    Instrucciones de instalación INSTALACIÓN DE LA ESTUFA 1 INSTALACIÓN DE LA CAJA DE EMPALMES Instale una caja de empalmes aprobada en un lugar de fácil acceso a través del frente del gabinete en donde pueda colocarse la estufa. El conducto de la estufa tiene 4 pies de longitud. Instale la caja de empalmes de modo que pueda alcanzarse...
  • Page 14 Instrucciones de instalación INSTALACIÓN DE LA ESTUFA 6 INSERTE LA ESTUFA EN EL ÁREA CORTADA Inserte la estufa centrada en el área cortada. Asegúrese de que el borde frontal del mostrador esté paralelo con respecto a la estufa. Asegúrese de verificar al final que todos los espacios especificados hayan sido respetados.
  • Page 15 Instrucciones de instalación INSTALACIÓN—CONEXIONES ELÉCTRICAS Cuando realice las conexiones de cables, utilice toda la extensión del conducto incluido. El conducto no debe reducirse. Con la estufa colocada en su lugar, abra el frente de la puerta del gabinete. Inserte los cables del conducto a través de la abertura de la caja de empalmes.
  • Page 16 Instrucciones de instalación LISTAS DE VERIFICACIÓN 1 LISTA DE VERIFICACIÓN PREVIA Retire toda la película protectora, si la hay, y las calcomanías. Verifique que todos los cables estén fijos y que no estén torcidos o en contacto con partes móviles. Verifique el nivel del aparato.

Table of Contents