9. Connect the FDD cable (26-pin to 26-pin) and CD-ROM cable
(40-pin to 40-pin). The other end of the FDD cable is connected
to connector CN10 on the PC board. The other end of the
CD-ROM cable is connected to connector CN18 on the PC board.
10. Slide the FDD assembly and slim CD-ROM assembly toward the
inside of the panel PC, as far as they will go.
11. Secure the two screws ("A") of the metal plate to the shielding
case.
A
A
Figure 4-5: Installing the FDD and slim CD-ROM drive
42
PPC-153 User's Manual
3.5" floppy drive
Metal plate