The scanner does not recognize the SD Card
• The SD Card is not properly formatted. Use the EZ Scan-SD
PC Application to reformat the card. If using Windows to format
the card, the card format must be FAT with 32kB clusters.
• The SD Card may not be inserted fully. Press the SD Card into
the slot until a click is heard and the card is fully inserted in the
slot.
• The SD Card may be defective. Replace with a new SD Card.
"Init SD Card" appears when the scanner is turned on
• The SD Card is not properly formatted. Use the EZ Scan-SD
PC Application to reformat the card.
• The SD Card may not be inserted fully. Press the SD Card into
the slot until a click is heard and the card is fully inserted in the
slot.
The EZ Scan-SD does not upload or download to/from the PC
• The SD Card must be removed and attached to an SD Card
adapter connected to a PC to upload or download frequency
data. The supplied USB cable should be used only when
charging the EZ Scan-SD, upgrading firmware or using the
CCDump feature.
Birdie Frequencies
Every scanner has birdie frequencies. Birdies are signals created
inside the scannerʼs receiver, which may interfere with
transmissions on the same frequencies.
If you program a frequency and hear only noise on that
frequency, it may be a birdie. If the interference is not severe,
you might be able to turn Squelch clockwise to omit the birdie.
Your scanner may have a few birdies that are so strong, rotating
the Squelch control clockwise will not solve the birdie problem.
If you suspect that a frequency you have programmed is being
affected by a birdie, try removing the antenna. Removing the
antenna will help determine if the interfering signal is a birdie
signal being generated inside of the scanner, or the result of an
external interference source. If the noise on a frequency is not
affected when the antenna is removed, it is almost certainly the
result of a birdie. If the noise disappears when the antenna is
EZ Scan-SD User Manual!
Page 59
Need help?
Do you have a question about the EZ Scan-SD PSR-700 and is the answer not in the manual?
Questions and answers