Getting Started; Unpacking The Ez Scan-Sd; Inserting The Batteries - Grecom EZ Scan-SD PSR-700 Owner's Manual

Getting Started

Unpacking the EZ Scan-SD

Unpack your EZ Scan-SD carefully. Save all documentation and
packing materials in case it is necessary to return your scanner
for repair.
WARNING:! Always protect the EZ Scan-SD from exposure to extreme heat
!
WARNING:! The EZ Scan-SD is not waterproof. Do not expose it to rain,
!

Inserting the batteries

Remove the door covering the battery compartment by pressing
gently where the door is marked OPEN and sliding the door
downwards until it stops, approximately 1/4". Lift the door away
from the radio.
Set the battery type selector switch to ALKA for non-
rechargeable alkaline batteries or NI-MH for rechargeable NiMH
batteries. Insert two AA batteries, taking care to ensure that the
batteries are inserted according to the polarity diagram shown
inside of the battery compartment. Replace the battery
compartment door by placing it back over the batteries and
sliding it upward gently until it locks in place.
WARNING:! Never operate the EZ Scan-SD with alkaline batteries if the
!
!
!
!
!
!
!
EZ Scan-SD User Manual!
or cold temperatures.
excessive humidity or moisture.
Battery Type Selection switch is set to the NI-MH position.
Intentionally or accidentally recharging non-rechargeable
batteries will cause them to overheat, leak or explode. Dispose
of rechargeable batteries properly by taking them to an
approved battery recycling facility. Many communities offer
battery recycling services - check with your local solid waste
management agency.
Page 23