Grecom EZ Scan-SD PSR-700 Owner's Manual page 29

PWR jack. To prevent corruption of SD Card data, always power
the EZ Scan-SD off using the front panel
connecting or disconnecting external power sources.
NOTE: ! Some external USB power supplies may generate RF noise that can
!
!
To access the PC/IF - PWR connector, use your fingernail or a
miniature screwdriver to open the switch cover at the bottom of
the cover as shown in Figure 7. To close the cover, press it down
against the housing until it snaps into place.
Lift here to open
Figure 7 - PC/IF jack cover
WARNING:! Always use the USB cable included with your EZ Scan-SD
!
!
!
EZ Scan-SD User Manual!
interfere with the EZ Scan-SDʼs reception. If interference occurs, try
disconnecting the EZ Scan-SD from the external power supply.
when connecting your scanner to a computer or to an external
power supply. Using other cables may damage the EZ
Scan-SD.
button before
Page 28