Troubleshooting - MK Diamond Products MK-5009G Owner's Operation Manual

MK-5000G
MK-5000G
Cooling Flow stopped
(A)
Check Cooling Flow
Control Valve is open.
NOTe: "Rodding" cooling channels is performed by removing the flow control valve and then insert-
ing a small wire rod through the cooling channel inlet, located on the underside of the Blade
Guard. The cooling channels should be "rodded" until each of the outlet ports are open and
free of foreign debris.
(D)
Verify Cooling Valve operation
by removing the valve from the
Blade Guard.
Block Saws - Pulley Combinations by MK Part Number
Blade Size
Motor Pulley 9-13 Hp Gas
Jack Shaft Pulley (Motor Side)
Jack Shaft Pulley (Arbor Side)
HD (1")
Motor Belts
Arbor Belts
Remove Transfer Tube from
Blade Guard.
Attach the Cooling Valve to the
Transfer Tube to verify flow –
if no flow, replace valve.
Gas Saws (9-13 Hp)
14 inch 20 inch
158470 160365
160362 160362
158959 160364
161135 158470
160366
160367
(B)
(E)
35

TrOUBLesHOOTiNG

24 inch
160365
160362
160364
161135
(C)
Place Water Pump in clean
water source and check for flow.
(if no flow go to step G)
(F)
Locate Cooling Channels inside
Blade Guard.