Table of Contents
Advertisement
[Note] When the Mini GBIC module is installed, the Mini GBIC (Gigabit fiber)
ports have higher priority than the Gigabit copper ports and supercede them.
It doesn't matter if the Gigabit copper port is connected before or after the
Mini GBIC port is connected. The Mini GBIC port always has higher priority
for connection. When the Mini GBIC port is connected, the Gigabit copper
ports are disabled.
Rear Panel
The 3-pronged power plug, on/off switch, and Ventilation fan are located at
the rear Panel of the DynaGST/1602G Gigabit Ethernet switch as shown in
Figure 2-2. The Switch will work with AC in the range 100-240V AC, 50-
60Hz.
LED Indicators
The LED Indicators give a real-time indication of system operating status.
There are three LED-indicators (1000, LNK/ACT, FDX/COL) for each Gigabit
port and one Power LED for the entire unit. The following table provides
descriptions of LED status.
Get user manuals:
See SafeManuals.com
Figure 2-2. Rear panel of the DynaGST/1602G Gigabit Ethernet switch
5
Advertisement
Table of Contents
