Top View - Arrow EH108-A Owner's Manual & Assembly Instructions

Step 6
L19
NOTE
The remainder of the building assembly
requires many hours and more than one
person. Do not continue beyond this point
if you do not have enough time to com-
plete the assembly today. A partially
assembled building can be severely
damaged by light winds.
Each screw and bolt in the wall re-
quires a washer.
1
Position a corner panel at the
corner of the floor frame as shown.
The widest part of each corner panel
must be placed along the side of the
building for all four corners. Fasten
the corner panel to the floor frame
with one screw.
Support the corner panel with a step
ladder until a wall panel is attached.
2
Attach the front wall panels to the
front corner panels, as shown. A small
gap will exist between front wall panel
and ramp.
3
Attach the wall panels to the rear
corner panels, as shown.
NOTE
Be careful to install the correct
panel in each position as shown
4
Double-check the part numbers of
the wall panels, before proceeding.
The floor frame must be square
and level or holes will not align.
● Parts Needed For ●
Corners
SIDE
STEP
8470
1
STEP
8470
4
8470
9373
Panels rest on
frame as shown
● ● ● ● ● 6515 Wall Panel (2)
● ● ● ● ● 9373 Front Wall Panel (2)
● ● ● ● ● 8470 Corner Panel (4)
Narrow
Side
8470
Wide Side
REAR

TOP VIEW

FRONT
6515
STEP
2
9373
6515
9373
8470
SIDE
8470
6515
STEP
3
9373
Crimped Rib
6515
Underneath
8470
Washer
8470
19