Tekmar tekmarNet 557 Installation & Operation Manual page 22

Toolbox Menu (2 of 3)
Setting
STATUS INFO
Displays the current status of the thermostat including
any overrides from the tekmarNet
Toggles between "Status Info" and the current status.
System Normal = Thermostat operating normally.
Override W1 = The tekmarNet
either forcing the W1 relay on or off.
Cooling Floor = Floor cooling is in effect.
WWSD = Warm Weather Shut Down is in effect.
CWSD = Cold Weather Shut Down is in effect.
Optimum Start Heat or Cool = The heating or
cooling system is started early in order to meet
temperature setpoint at Event 1 or Event 3.
Floor Max = The floor has reached its maximum
temperature. Some under heating could occur.
Floor Min = The floor is operating at its minimum
temperature. Some over heating could occur.
Baseload On = Baseload heating is on even
though the room temperature is satisfied. Reduces
heat up time when the sun sets in the evening.
Hydronic Heat Off = The air group master is in
cooling mode and air group member thermostats'
heating is shut off.
Interlock Wait = The thermostat is switching between
heating to cooling or from cooling to heating.
Access Level: Installer, User
Conditions: Always available.
ADDRESS
®
The tekmarNet address of this thermostat.
To manually set the address, use the up or down
arrow buttons while in the Installer access level.
Access Level: Installer
Conditions: tekmarNet
SOFTWARE AND TYPE VERSION
Displays the software version and the tekmar type
number.
Access Level: Installer, User, Limited, Secure
Conditions: Always available.
A Watts Water Technologies Company
®
system control.
®
system control is
®
2 or 4 detected.
22 of 48
Display
Range: See Description
Default: System Normal
Range: AUTO, 01 to 24,
b:01 to b:24, 1:01 to 1:24,
2:01 to 2:24, 3:01 to 3:24
Default: AUTO
Range: 557
Default: 557
© 2012 557_D - 08/12