Steps For Finalizing The Installation - Travis Industries DVS GSR Owner's Manual

26

Steps for Finalizing the Installation

1. Remove the glass (see page 20).
NOTE: If using propane (LP) convert the appliance prior to installing the logs.
2. We recommend you purge the gas line at this time (with the glass removed). This allows gas to be detected
once it enters the firebox, ensuring gas does not build up.
3. Make sure the accent light bulb is in place.
NOTE: Take care to not touch the bulb with your fingers – use a cloth or paper towel).
4. Install the four AA batteries and receiver cover (included in the owner's pack - see illustration below). The AA
batteries act as a power backup in case the household (AC) power goes out and are required for operation.
Install the 9v battery (included in the owner's pack) into the battery holder (see illustration below). This battery is
for the control panel lights. Install three AAA batteries into the remote (see illustration below). Synchronize the
transmitter to the receiver (see page 28).
© Travis Industries
Finalizing the Installation
CONTINUOUS
BLOWER ACCENT LIGHT
PILOT
HIGH
HIGH
OFF
GREEN SMART
PILOT LOW LOW
The remote
uses 3 AAA
batteries.
Battery Holder for
Control Panel Lights
ON REMOTE OFF
PRG
OFF
The remote receiver
uses 4 AA batteries.
4100105 100-01245_000