Installation Warnings; Packing List; Additional Items Required; Items Packed With The Face - Travis Industries DVS GSR Owner's Manual

Installation (for qualified installers only)

Installation Warnings

• Failure to follow all of the requirements may result in property damage, bodily
injury, or even death.
• This heater must be installed by a qualified installer who has gone through a
training program for the installation of direct vent gas appliances.
• This appliance must be installed in accordance with all local codes, if any; if
not, follow ANSI Z223.1 and NFPA 54(88).
• In Manufactured or Mobile Homes must conform with Manufactured Home
Construction and Safety Standard, Title 24 CFR, Part 3280, or, when such a
standard is not applicable, the Standard for Manufactured Home Installations,
ANSI/NCSBCS A225.1. This appliance may be installed in Manufactured
Housing only after the home is site located.
• The heater is designed to operate on natural gas, or propane (LP).
• All exhaust gases must be vented outside the structure of the living-area.
Combustion air is drawn from outside the living-area structure.
• Notify your insurance company before hooking up this heater.
• The requirements listed below are divided into sections. All requirements
must be met simultaneously. The order of installation is not rigid – the
qualified installer should follow the procedure best suited for the installation.

Packing List

•
LP Conversion Kit
•
Log Set
•
Cove Covers
•
Panel Trim Cover-Up Labels (see page 19)

Additional Items Required

•
Faceplate
•
Simpson Duravent 6-5/8" to 3" & 3" Co-Linear Adapter with flashing
•
3" (76mm) Diameter Gas Liner (2)
•
Direct Vent Cap (Use Simpson Duravent High Wind Cap)
•
Gas Line Equipment (shutoff valve, pipe, etc.)

Items Packed with the Face

•
Face with attachment hardware (Note: use the cove covers included with the heater)
•
Face Installation Instructions

Order of Installation

1 If the heater is to use LP (propane), convert the appliance (see page 42).
2 Install gas line into the fireplace (do not connect to unit).
3 Position the heater.
4 Connect the gas line and gas vent to the appliance.
5 Install the optional surround panels and trim. Attach the on/off switch.
6 Follow the instructions under "Finalizing the Installation" on page 26.
© Travis Industries
•
"Fireplace Altered" tag (attach to the fireplace)
•
Remote Control
•
Cover Plate for Receiver (with screws)
4100105
7
100-01245_000