Travis Industries DVS GSR Owner's Manual page 43

Optional Equipment (for qualified installers only)
4 Follow the directions below to replace the orifices (NOTE: Orifice sizes are listed in DMS).
1/2" Wrench
5 Replace the manifold cover. Place two orifice gaskets (included with appliance) on the front orifice
(see illustration below).
© Travis Industries
Rear Burner Orifice
Front Burner Orifice
Use a 1/2" open end wrench
a
to unscrew the two orifices.
c
Screw each LP orifice in so the
orifice protrudes 15/16" (24mm)
(indicating full insertion).
15/16"
24mm
b
Apply thread sealant to the LP
orifices prior to installation. Use
the chart below to identify the
correct orifices.
Look here for the orifice identification
NG
#50
Front
#47
Rear
4100105
LP
#56
#56
100-01245_000
43