Part Identification Chart - Weider Sa 1-22 Standard Bench Manual

PART IDENTIFICATION CHART

Use the drawings below to identify the small parts needed for assembly. The number in parentheses below each
drawing is the key number of the part, from the PART LIST near the end of this manual. Note: If a part is not in
the hardware kit, check to see if it has been preassembled. Extra parts may be included.
M8 Locknut
M10 Locknut (31)
M8 Washer (39)
M6 Washer
(38)
M10 Washer (30)
(22)
M6 x 40mm Screw (32) M8 x 45mm Bolt (28)
M6 x 16mm
M10 x 35mm
Screw (24)
Carriage Bolt (37)
M10 x 60mm Bolt (25)
M10 x 68mm Bolt (27)
M10 x 135mm Bolt (23)
5