Weider Sa 1-22 Standard Bench Manual page 7

2. Orient the Crossbar (2) so that the warning
decals are in the positions shown.
Attach one end of the Crossbar (2) to two Joint
Plates (35, 41) with two M10 x 68mm Bolts (27)
and two M10 Locknuts (31). Do not tighten the
Locknuts yet.
Attach the other end of the Crossbar (2) in
the same way.
3. Orient the Base (33) so that the square holes are
facing the floor.
Attach the Base (33) to the Front Leg (4) with
two M10 x 35mm Carriage Bolts (37) and two
M10 Locknuts (31).
4. Attach the Front Leg (4) to the Frame (3) with
two M8 x 45mm Bolts (28), two M8 Washers
(39), and two M8 Locknuts (38). Make sure that
the Locknuts are in the indicated hexagonal
holes; do not tighten the Bolts yet.
2
41
35
27
3
4
31
33
37
4
28 39
Hexagonal
Holes
4
7
31
Warning
Decals
2
31
Square Holes
3
38