Assembly - Weider Sa 1-22 Standard Bench Manual

ASSEMBLY

•• To hire an authorized service technician to
assemble this product, call 1-800-445-2480.
Assembly requires two persons.
•• Because of its size and weight, assemble the
weight bench in the location where it will be used.
Make sure that there is enough clearance to walk
around the weight bench as you assemble it.
•• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you  nish all assembly steps.
•• Left parts are marked “"L”" or “"Left”" and right parts
are marked “"R”" or “"Right.”"
1. Orient one of the Uprights (1) so that the Upright
Cover (10) is on the side shown.
Next, identify one Joint Plate A (35) and one
Joint Plate B (41); the Joint Plates have “"A”" and
“"B”" stickers. Orient the Joint Plates as shown,
with the diamond patterns facing away from the
Upright (1).
Attach the Joint Plates (35, 41) to the Upright (1)
with two M10 x 68mm Bolts (27) and two M10
Locknuts (31). Do not tighten the Locknuts
yet.
Orient the other Upright (1) and the other
Joint Plates (35, 41) as shown; attach the
Joint Plates as described above.
•• To identify small parts, see page 5.
•• The following tools (not included) may be required
for assembly:
two adjustable wrenches
one rubber mallet
one standard screwdriver
one Phillips screwdriver
Assembly may be easier if you have a set of
wrenches. To avoid damaging parts, do not use
power tools.
1
10
1
35
27
6
41
31
1
35
41