Weider Sa 1-22 Standard Bench Manual page 8

5. Attach the Frame (3) to the Crossbar (2) with two
M10 x 68mm Bolts (27) and two M10 Locknuts
(31). Do not tighten the Locknuts yet.
6. Insert the Backrest Support (14) from the direc-
tion shown into one of the three sets of holes in
the Uprights (1). Rotate the Backrest Support
so that the locking pin is wrapped around the
Upright (see the inset drawing).
See steps 1, 2, and 5. Tighten the M10
Locknuts (31).
See step 4. Tighten the M8 x 45mm Bolts (28).
7. Apply a small amount of the included grease to
an M10 x 60mm Bolt (25).
Attach the Leg Lever (6) to the Front Leg (4) with
the M10 x 60mm Bolt (25) and an M10 Locknut
(31). Do not overtighten the Locknut; the Leg
Lever must pivot easily.
5
6
14
Locking
Pin
Locking
Pin
7
4
31
6
8
27
2
3
31
1
1
Grease
25