Status Control - TDK-Lambda ZERO-UP 200W User Manual

TABLE OF CONTENTS: ZUP SERIES
5.3 Remote programming via RS232.....................................................
5.3.1 Introduction
5.3.2 Rear panel connectors pinout
5.3.3 RS232 cable ............................................................................
5.3.4 Linking power supplies
5.4 Remote programming via RS485 .....................................................
5.4.1 Introduction
5.4.2 RS485 cable
5.4.3 Linking power supplies
5.5 ZUP series command set description
5.5.1 ID control commands...............................................................
5.5.2 Initialization control
5.5.3 Output control..........................................................................

5.5.4 Status control ..........................................................................

5.5.4.1 Registers structure
5.5.4.2 Status control commands ....................................................
5.6 Communication Protocol..................................................................
5.6.1 General information
5.6.2 Accessing a ZUP unit
5.6.3 End of message
5.6.4 Communication Test set up.................................................... pg.48
5.7.Service Request................................................................................. pg.49
5.7.1 Service Request (SRQ)
5.7.2 Service Request message
5.7.3 Service Request enable/disable commands
CHAPTER 6. Maintenance
6.1 Introduction
6.2 Units under warranty
6.3 Periodic Maintenance
6.4 Adjustment and calibration
6.5 Part replacement and repairs
6.6 Fuse ratings
USER'S MANUAL INDEX
................................................................... pg.50
...................................................................... pg.51
pg.39
pg.40
pg.41
pg.42
pg.43
pg.45
pg.46
pg.47