Using The Inreach As A Standalone Device; Power; Tracking; Message - DeLorme inReach User Manual

Using the inReach as a Standalone Device

You can use the inReach as a standalone device when you don't want to use it with an Android phone or
Earthmate PN-60w GPS.

Power

• To turn the inReach on, press and hold the Power button until the Power LED flashes green and then release the
button. When powered on, the Power LED will flash green once every three seconds.
• To turn the inReach off, press and hold the Power button until the Power LED flashes rapidly and then release the
button.
• When power is low, the Power LED flashes red once every three seconds. See Batteries on page 4 for more
information.
• When there is not enough power to send any messages or tracking points, the Power LED flashes red every 1.5
seconds. See Batteries on page 4 for more information.

Tracking

The Tracking button allows you to send your location to explore.delorme.com when you are using the inReach in
standalone mode. When you are moving, your location is sent every 10 minutes. When you are stationary, your location
is sent every four hours; if you move more than 100 meters, tracking at 10 minute intervals resumes.
• To start tracking, press and hold the Tracking button until the Tracking LED flashes and then release the button.
The LED will flash green once every three seconds while tracking until you cancel tracking or turn off the inReach.
• To stop tracking, press and hold the Tracking button until the Tracking LED flashes rapidly and then release the
button.
You can also use tracking when connected with an Earthmate PN-60w (see page 12) or Android phone (see page
20). In addition, tracking can be initiated from explore.delorme.com by anyone who can log in to your account. See
the Help at explore.delorme.com for more information.

Message

The Message button lets you send predefined inReach messages that you created on explore.delorme.com. You can
create up to three messages—it's a good idea to make a note of the messages in the proper order and take it with you.
The message is sent to contacts you designated on explore.delorme.com when you created the message.
• To send predefined message one, press and hold the Message button until the Message LED flashes once and
then release the button. The Message LED will flash once every three seconds until the message is sent.
• To send predefined message two, press and hold the Message button until the Message LED flashes twice and
then release the button. The Message LED will flash twice every three seconds until the message is sent.
• To send predefined message three, press and hold the Message button until the Message LED flashes three
times and then release the button. The Message LED will flash three times every three seconds until the message
is sent.
Note The LED flashes for choosing the message will cycle in order until you release the Message button to make a
selection.
DeLorme inReach User Manual | Using the inReach as a Standalone Device 5