Access The System; Enter Or Quit The Key Operator System - Oce VarioPrint 2070 Prémia Class User Manual

Access the System

Enter or quit the key operator system

Introduction
The key operator system contains the settings to change, or restore, the default configu-
ration of the Océ VarioPrint 2070 Prémia Class.
You can enter the key operator system if the Océ VarioPrint 2070 Prémia Class is not
processing a job. A PIN is required to make the settings available. Only Océ Service can
change the Key Operator PIN.
The changes made in the Key Operator System are applied after you have left the Key
Operator System.
Before you begin
Make sure that the Océ VarioPrint 2070 Prémia Class does not process or announce a
job.
Illustration
[5] Enter the Key Operator System with a PIN
[6] Quitting the Key Operator System
Entering the Key Operator System
Select the 'Copy' mode.
1.
Activate the 'Extra' section.
2.
Open the 'Special settings' card.
3.
Press the 'System management' function key.
4.
Enter or quit the key operator system
Chapter 1 - Introduction 21