Digital Channels; To Connect The Digital Probes To The Device Under Test; Probe Cable For Digital Channels - Agilent Technologies 2000 X-Series User Manual

6

Digital Channels

To connect the digital probes to the device under test

1 If necessary, turn off the power supply to the device under test.
2 Connect the digital probe cable to the DIGITAL Dn - D0 connector on
C A U T I O N
Use only the Agilent logic probe and accessory kit supplied with the mixed-signal
oscilloscope (see
3 Connect the ground lead on each set of channels (each pod), using a
86
Turning off power to the device under test would only prevent damage
that might occur if you accidentally short two lines together while
connecting probes. You can leave the oscilloscope powered on because
no voltage appears at the probes.
the front panel of the mixed- signal oscilloscope. The digital probe cable
is keyed so you can connect it only one way. You do not need to
power- off the oscilloscope.

Probe cable for digital channels

"Accessories Available"
probe grabber. The ground lead improves signal fidelity to the
oscilloscope, ensuring accurate measurements.
on page 286).
Agilent InfiniiVision 2000 X-Series Oscilloscopes User's Guide
Off