Beam Oceana 800 User Manual page 38

Setting up call summary
Select Menu > Settings > Call settings > Call
summary and then use the navigation and
centre selection keys to make your selection.
The default setting is on.
When Call summary is activated, the date, time
and duration of the call is displayed.
Setting up and using speed dial
First, select Menu > Settings > Call settings >
Speed dialling and then use the navigation
and centre selection keys to make your
selection. The default setting is on. Eight
speed dial slots are available, from 2-9. Speed
dial 1 is reserved for voicemail.
From the main screen, press and hold down
for a few seconds the number key that you
would like to associate with a contact. If the
number is not yet assigned, a pop-up will
ask if you wish to assign a contact to the key.
Select Yes and a list of Phonebook contacts
is displayed. Use the navigation keys to
highlight the contact and then the contact's
details. Press OK to save your selection.
38
Alternatively, select Contacts > Phonebook. Use
the navigation keys to highlight the contact
name, press the centre selection key to open or
select Options > Open. Highlight the number to
which you would like to assign the speed dial,
eg. Mobile. Select Options and select Assign
speed dial. Highlight a speed dial slot marked
Unassigned, press the centre selection key to
assign the phone number to that speed dial slot.
To remove speed dial, follow the instructions
above and select Remove speed dial.
To speed dial, hold down the appropriate
number of the keypad for a few seconds and the
Terminal will automatically dial the number.
Setting any key answer
Select Menu > Settings > Call settings > Any key
answer and select On. The default setting is off.
When activated, press any key to answer a call.
Deleting all call logs
Select Menu > Call Log. Select Options > Clear
all. Press Yes to confirm.
Advanced call features
Advanced call features are controlled by the
Inmarsat network. To check or change these
features, the Terminalmust be connected to the
satellite with a signal strength of at least two bars.
Sending your caller ID
Select Menu > Settings > Call settings > Send
my caller ID, then select On, Off or Set by
network and press OK. Set by network leaves
it to the network to select whether Caller ID is
displayed. The default setting is Set by Network.
When Send my caller ID is on, your caller ID will
be displayed on the recipient's phone. If this
feature is switched off, your caller ID will be
hidden and Withheld displayed in its place.
Setting up call waiting
Select Menu > Settings > Call settings > Call
waiting, and select Activate. There may be a
short delay before the network responds. Call
waiting activated will appear when the setting
has been enabled. The Call waiting default
setting is off. From the Call waiting menu you
can also select to Check status or Deactivate. To
use call waiting, see "Using call waiting" on page
37 for more information.