Registration - Beam Oceana 800 User Manual

Alternatively, the SIM PIN can be disabled so
that the terminal will automatically register.
Please use the Falcon application to perform
this SIM card configuration. The Falcon also
allows the SIM PIN to be changed, and the PUK
to be entered if the SIM is locked.
NOTE
If you enter the PIN incorrectly 3 times, the SIM
card locks, and you need to enter the PUK. You
must use the PUK code supplied by your Service
Provider to unlock the SIM. If you dont have a PUK
code please contact your Service Provider.
SIM PUK
If you have locked your SIM card, you can enter
the PUK and then reset the PIN via Falcon.
You must use the PUK code supplied by your
Service Provider to unlock the SIM.
Alternatively you can enter the PUK via the
RJ11/POTS handset:
1. Turn on power to the terminal. The Signal
LED will flash RED.
28
2. Lift the RJ11/POTS handset, and listen for
a PUK tone. (See "Types of tones on RJ11/
POTS" page 58).
3. Enter the PUK on the handset keypad,
followed by the # button.
4. Hang up the RJ11/POTS handset and wait
for the Oceana 800 terminal to acquire
lock and registration.
The terminal has now loaded a default PIN
of "8888" into the SIM. The Oceana 800
terminal has also DISABLED the SIM PIN
requirement on powering up of the terminal.
NOTE
If you require to change the SIM PIN from the
default PIN, please use Falcon
NOTE
Refer to page 57 for more information on "security
features controlled by the SIM card".

Registration

1. Turn ON power to the terminal. The
Signal LED will start flashing RED.
2. Wait for the terminal to register to the
Inmarsat network and acquire GPS lock.
This may take up to 2 minutes.
3. Inmarsat will be displayed in the top left of
the screen once registration has occurred.
4. Ensure you have at least two bars of
signal strength.
5. The Status LED will then be solid GREEN
or YELLOW and the terminal is now
ready for calls.
NOTE
If your SIM has the PIN enabled, see section
"SIM PIN USE" (page 27) to enter PIN, or to
permanently disable PIN. The terminal will not
register if PIN is required.