Beam Oceana 800 User Manual page 59

Oceana 800 Function Keypad
Location Button Action
Mode
Mute Press In a Call:
on/off Mute the microphone (uplink) on the privacy handset.
Up/Down In a Call:
Increase/decrease volume on speakerphone or privacy handset.
Out of Call:
OR
Increase/decrease volume of incoming ring tone on the
speakerphone.
Out of Call:
Brightness
dual button Enter LED brightness change mode. Press UP and DOWN arrows
simultaneous to vary intensity. Mode will automatically exit after 5 seconds after
+
press the last button press.
(1 second)
Speakerphone In a Call:
press ON/OFF Terminate call if speakerphone mode is active
Activate speakerphone mode if Privacy Handset mode is active.
Out of Call:
Answer inbound call in speakerphone mode
Instant When Instant Message enabled/configured a 0->3 second press
Message (IM)* triggers an instant message.
A 7 second press will clear the instant message.
When Instant Message disabled no functionality.
Tracking* When tracking enabled a momentary press results in a tracking
message being queued for sending.
When tracking disabled no functionality.
*This action is optional, only when the Tracking Mode for your Oceana 800 is configured and activated.
LED/Sound
LED turns RED - Muted
LED turns OFF - Not muted
LED flashing Yellow - RJ11/POTS in use
Audio will sound louder/quieter with each press.
A beep will sound indicating the increased/decreased ring tone volume
All LED's will change to WHITE and a single beep will sound when entering brightness
change mode.
A short double beep will sound when exiting change mode.
LED turns GREEN - Speakerphone mode active
LED turns OFF - Speakerphone mode not active
IM functionality disabled – No backlight, no colour
IM functionality enabled but not triggered – LED should be Green
IM button pressed LED changes from GREEN to solid RED (a beep will sound when triggered)
Once first emergency message has been sent LED changes from solid RED to flashing RED
Once remote acknowledgement of instant message, LED changes from flashing RED to slow
flashing YELLOW.
If audio tones for instant message is enabled:
A beep will sound from the buzzer when the Instant Message is triggered
A double beep will sound from the buzzer when the Instant Message is cleared
LED On and Red - Tracking enabled and NO GPS fix
LED on and Green - Tracking enabled and GPS fix
LED Flashing Green - Track button has been pressed (beep will sound from the buzzer). Will stay
flashing for 5 seconds to indicate message sending. OR Transceiver upgrade mode active.
LED Flashing Red - Firmware upgrade mode active
BEAM Oceana 800 - Installation & User Manual 59