Tracking & Instant Message Configuration (Optional); Placing Voice Calls - Beam Oceana 800 User Manual

Tracking & Instant Message
Configuration (optional)
It is optional to activate the Tracking function
on your terminal. Please refer to the Falcon
software to enable this function.
Instant Message can be enabled via the Tracking
configuration. This option can be activated
through the below link as required.
www.beamcommunications.com/falcon
NOTE
If the Beam alarm loop is going to be used
with an external button, remember to enable
this external loop in the Falcon settings. Once
enabled, the loop will be armed and activated
with an open-loop condition.
To avoid false triggering, be sure to have the
normally closed button wired into the Instant
Message loop, before applying power.

Placing Voice Calls

Speakerphone Call Use
Mobile Originating
1. By default the Oceana 800 will start
all calls in speakerphone mode when
dialing on the keypad if RJ11 and privacy
handset remain on hook.
2. Dial using the full Inmarsat dialing sequence
eg. 00 country code and telephone number
on the keypad. Press the GREEN key
on the Oceana 800 keypad to start the
connection.
3. A message on the display will indicate the
call is progressing.
4. Once the call is connected, the STATUS LED
will flash to indicate a call is in progress.
5. To terminate the call, Press the RED key
on the Oceana 800 keypad, or press the
speakerphone button.
Options:
A. During a call, you may take the privacy
handset out of its cup. This automatically
directs the call audio to the privacy handset.
B. To return the call back to "speakerphone"
mode, press the speakerphone button,
then return the privacy handset to its cup.
BEAM Oceana 800 - Installation & User Manual
Mobile Terminating
1. Answer the incoming call by pressing the
speakerphone button or the GREEN key on
the Oceana 800 keypad.
2. Once the call is in progress, the same options
are available as described in "Speakerphone
Phone Call – Mobile Originating"
3. Press the RED key on the Oceana 800
keypad or press the speakerphone button
to terminate the call.
Privacy Handset Use
Mobile Originating
1. Remove the privacy handset from its cup
2. Dial using the full Inmarsat dialing
sequence eg. 00 country code and
telephone number on the Oceana 800
keypad whilst docked. Press the GREEN
button to start the connection.
3. A message is displayed on the screen
display to indicate a call is in progress.
4. Once the call is connected, the STATUS LED
will flash to indicate a call is in progress.
5. Press the RED key on the Oceana 800
keypad or return the privacy handset to its
cup to terminate the call.
29