Beam Oceana 800 User Manual page 20

4) Privacy Handset & Mounting Cup
The Privacy Handset is part of the Oceana 800,
providing a local handset function.
The Privacy Handset connects to the rear of the
Oceana 800 via a RJ9 connector. The privacy
handset is connected beneath the rear panel
of the Oceana 800. Once connected, the cable
should be run out through the foam and placed
in the 'S' channel through the base of the
terminal as illustrated below:
Mounting Cups
There are two unique mounting cups for the
privacy handset. (1) springless cup for either
a desk mounted position or a wall mounted
position. (2) spring cup for rough environments.
20
Changing Cups
1. Unhook the privacy handset from cup.
2. Use a flat screw driver in one of the two
side slots to leaver the cup cover out
exposing the 3 screws.
3. Unscrew 3 screws with a phillips screwdriver.
4. Detach the cup and replace with the
spring or springless cup.
2
3
4
NOTE
When the cup is removed this will expose the locking
bolt screw hole. (Refer to 'Locking Bolt' on page 19.)
(1) Springless Cup for Normal light-use
Desk mounted cradle position.
The 'springless' cup is shown fitted to the Oceana
800 with the mounting clip in a 'flush' position.
1
Wall mounted cradle position.
The mounting clip can be slid out and
reversed, revealing a protruding edge that
the Privacy handset rests upon. For a wall
mounted terminal this retains the privacy
handset while allowing the handset to be
easily removed when in a call.