DFI CR101-D User Manual page 32

SATA Configuration
This section is used to configure SATA functions.
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [IDE]
SATA Test Mode [Enabled]
Serial ATA Port 0 Empty
Software Preserve Unknown
Serial ATA Port 1 Empty
Software Preserve Unknown
Serial ATA Port 2 Empty
Software Preserve Unknown
Serial ATA Port 3 Empty
Software Preserve Unknown
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
SATA Controller(s)
This field is used to enable or disable the Serial ATA channels.
SATA Mode Selection
IDE Mode
This option configures the Serial ATA drives as Parallel ATA storage devices.
AHCI Mode
This option allows the Serial ATA devices to use AHCI (Advanced Host Controller Inter-
face).
SATA Test Mode
This field is used to enable or disable the Serial ATA test mode.
Chapter 3 BIOS Setup
Chapter 3
Enable or disable SATA
Device.

Select Screen

Select Item
Enter: Select
+/ -:
Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
32
If AHCI is selected in the SATA Mode Selection, it will display the following information:
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Advanced
SATA Controller(s) [Enabled]
SATA Mode Selection [AHCI]
SATA Test Mode [Disabled]
Agressive LPM Support [Enabled]
Serial ATA Port 0 Empty
Software Preserve Unknown
Port 0 [Enabled]
Hot Plug [Disabled]
External SATA [Disabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Serial ATA Port 1 Empty
Software Preserve Unknown
Port 1 [Enabled]
Hot Plug [Disabled]
External SATA [Disabled]
SATA Device Type [Hard Disk Driver]
Spin Up Device [Disabled]
Serial ATA Port 2 Empty
Software Preserve Unknown
Version 2.14.1219. Copyright (C) 2011 American Megatrends, Inc.
Port 2 [Enabled]
Hot Plug [Disabled]
External SATA [Disabled]
Spin Up Device [Disabled]
Serial ATA Port 3 Empty
Software Preserve Unknown
Port 3 [Enabled]
Hot Plug [Disabled]
External SATA [Disabled]
Spin Up Device [Disabled]
Serial ATA Port 0 to Serial ATA Port 3
These fields are used to configure the connected SATA devices.
Aggressive LPM Support
Enter PCH to aggressively enter link power state.
Determines how SATA
controller(s) operate.

Select Screen

Select Item
Enter: Select
+/ -: Change Opt.
F1: General Help
F2: Previous Values
F3: Optimized Defaults
ESC: Exit
www.dfi .com