Cpu; Installing The Cpu - DFI CR101-D User Manual

5. Grasping the module by its edges, align the module into the socket at an approximately 30
degrees angle. Apply firm even pressure to each end of the module until it slips down into
the socket. The contact fingers on the edge of the module will almost completely disappear
inside the socket.
6. Push down the module until the clips at each end of the socket lock into position. You will
hear a distinctive "click", indicating the module is correctly locked into position.
Clip
Chapter 2 Hardware Installation
Chapter 2
Clip
11

CPU

Overview
The system board is equipped with a surface mount PGA 988B CPU socket.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.

Installing the CPU

1. Make sure the PC and all other peripheral devices connected to it has been powered down.
2. Disconnect all power cords and cables.
3. Locate the PGA 988B
socket on the system
board.
4. Make sure the screw is in
its unlock position. If it's
not, use a screwdriver to
turn the screw to its unlock
position.
Lock
Unlock
www.dfi .com