Standby Power Led; Peripheral Power - DFI CR101-D User Manual

Standby Power LED

This LED will lit red when the system is in the standby mode. It indicates that there is power
on the system board. Power-off the PC and then unplug the power cord prior to installing any
devices. Failure to do so will cause severe damage to the motherboard and components.
Chapter 2 Hardware Installation
Chapter 2

Peripheral Power

Standby Power LED
The peripheral power connector supplies power to the SATA drive and IDE hard disk drive.
Connect one end of the provided power cable to the peripheral power connector and the other
ends to your storage devices.
25
Peripheral Power
1
+12V
Ground
Ground
+5V
4
Connect to the peripheral
power connector
Connect to
storage devices
www.dfi .com