Table of Contents
Advertisement
Audio
Rear audio
Mic-in
Line-in
Line-out
10
9
Line2-JD
Line2-L
Key
Front_IO_Sense
Mic2-JD
Line2-R
Presence Signal
Mic2-R
Front
Mic2-L
audio
GND
2
1
Rear Audio
The system board is equipped with 3 audio jacks. A jack is a one-hole connecting interface for
inserting a plug.
•
Mic-in Jack (Pink)
This jack is used to connect an external microphone.
•
Line-in Jack (Light Blue)
This jack is used to connect any audio devices such as Hi-fi set, CD player, tape player,
AM/FM radio tuner, synthesizer, etc.
•
Line-out Jack (Lime)
This jack is used to connect a headphone or external speakers.
Front Audio
The front audio connector allows you to connect to the second line-out and mic-in jacks that
are at the front panel of your system.
BIOS Setting
Configure the onboard audio in the Chipset menu ("South Bridge" submenu) of the BIOS.
Refer to chapter 3 for more information.
Driver Installation
Install the audio driver. Refer to chapter 4 for more information.
Chapter 2 Hardware Installation
Chapter 2
I/O Connectors
S/PDIF Connector
SPDIF out
Key
Ground
SPDIF in
+5V
1
5
The S/PDIF connector is used to connect an external S/PDIF port. Your S/PDIF port may be
mounted on a card-edge bracket. Install the card-edge bracket to an available slot at the rear
of the system chassis then connect the audio cable to the S/PDIF connector. Make sure pin 1
of the audio cable is aligned with pin 1 of the S/PDIF connector.
21
www.dfi .com
Advertisement
Table of Contents
