Front Panel Connectors
HDD-LED - HDD LED
This LED will light when the hard drive is being accessed.
RESET SW - Reset Switch
This switch allows you to reboot without having to power off the system.
PWR-BTN - Power Switch
This switch is used to power on or off the system.
PWR-LED - Power/Standby LED
When the system's power is on, this LED will light. When the system is in the S1 (POS - Power
On Suspend) state, it will blink every second. When the system is in the S3 (STR - Suspend To
RAM) state, it will blink every 4 seconds.
Pin Pin Assignment
3
HDD Power
HDD-LED
5
Signal
PWR-LED
7
Ground
RESET SW
9
RST Signal
PWR-BTN
11
N.C.
Chapter 2 Hardware Installation
Chapter 2
1
2
PWR-LED
HDD-LED
RESET-SW
PWR-BTN
11
12
Pin Pin Assignment
2
LED Power
4
LED Power
6
Signal
8
Ground
10
Signal
Expansion Slots
Mini PCI Express
PCI Express x16
PCI Express x16 Slot
Install PCI Express x16 graphics card, that comply to the PCI Express specifications, into the
PCI Express x16 slot. To install a graphics card into the x16 slot, align the graphics card above
the slot then press it down firmly until it is completely seated in the slot. The retaining clip of
the slot will automatically hold the graphics card in place.
Mini PCIe Slot
The Mini PCIe socket is used to install a Mini PCIe card. Mini PCIe card is a small form factor
PCI card with the same signal protocol, electrical definitions, and configuration definitions as
the conventional PCI.
26
www.dfi .com