Error Messages - Martin MAC III AirFX User Manual

Error messages

Short code Full-text message
BOTV BOOT NOT VALID
Decentralized firmware in a module cannot be replaced or does not match bank. FIxture firmware
bank must be replaced.
BTCO BASE TMP CUTOFF
At least one base PCB temperature sensor has reported temperature above the maximum for more
than 5 minutes. A fan may be defective or the ambient temperature may be too high.
BTSE BASE TMP SEN ERR
A temperature sensor in the base is not communicating normally. Fans are set to full speed until the
error is rectified.
C1ER COLORWHEEL 1 ERROR
CDCM CAL DATA CMY
Unable to read/write data to external EEPROM board (calibrate data) on CMY module.
CDEF CAL DATA EFFECT
Unable to read/write data to external EEPROM board (calibrate data) on Effect module.
CDPT CAL DATA P/T
Unable to read/write data to external EEPROM board (calibrate data) on Yoke.
CDZF CAL DATA Z/F
Unable to read/write data to external EEPROM board (calibrate data) on Zoom/Focus module. Bad
connection or defective components.
CECH COM ERR CHARGER
I2C communication between main controller and charger failed.
CECM COM ERR CMY
CAN communication between main controller and CMY driver failed.
CECO COM ERR COOLING
CAN communication between main controller and cooling driver failed.
CEEF COM ERR EFFECT
CAN communication between main controller and effects driver failed.
CEPT COM ERR P/T
CAN communication between main controller and pan/tilt driver failed.
CEPU COM ERR PU
I2C communication between main controller and ballast failed.
CEUI COM ERR UI
User interface communication failure.
CEZF COM ERR Z/F
CAN communication between main controller and zoom/focus driver failed.
COLD FIXTURE COLD
The fixture is too cold for some effects to function normally. Effects are disabled until temperature is
normal. Leave power applied to warm up fixture.
CTER CTC ERROR
CTC position indexing system error. Fixture will work normally but CTC flags may lose position and
hit mechanical stop.
CYER CYAN ERROR
Cyan position indexing system error. Fixture will work normally but cyan flags may lose position and
hit mechanical stop.
DIER DIMMER ERROR
Dimmer position indexing system error. Fixture will work normally but dimmer may lose position and
hit mechanical stop.
DROP DEVICE DROPPED
The fixture has been dropped and may have suffered damage.
EEDF EEPROM WRITE ERR
No valid EEPROM in a CAN module. Writing default data to EEPROM based on CAN address.
EEDF EEPROM CHARGER
Writing default data to charger EEPROM based on its CAN address.
EEDF EEPROM Z7F
Writing default data to zoom/focus module EEPROM based on its CAN address.
EEDF EEPROM PAN/TILT
Writing default data to pan/tilt EEPROM based on its CAN address.
EEDF EEPROM EFFECT
Writing default data to effect EEPROM based on its CAN address.
Table 5: Error messages
Service and display messages 55