Safety Information - Martin MAC III AirFX User Manual

Safety Information

Read the safety precautions in this section before
installing, powering, operating or servicing this
The following symbols are used to identify important safety information on the product and in this manual:
DANGER! DANGER!
Safety hazard. Refer to
Risk of severe manual before
injury or death. installing,
powering or
servicing.
Warning! Risk Group 3 (high risk) product according to EN 62471. Do not view the light output with
optical instruments or any device that may concentrate the beam.
This product is for professional use only. It is not for household use.
This product presents risks of severe injury or death due to fire and burn hazards, electric shock, lamp
explosion and falls.
Read this manual before installing, powering or servicing the fixture, follow the safety precautions listed
below and observe all warnings in this manual and printed on the fixture.
If you have questions about how to operate the fixture safely, please contact your Martin supplier or call the
Martin 24-hour service hotline on +45 8740 0000, or in the USA on 1-888-tech-180.
P R O T E C T I O N F R O M E L E C T R I C S H O C K
• Disconnect the fixture from AC power before removing or installing any cover or part – including the lamp
– and when not in use.
• Ensure that the fixture is electrically connected to ground (earth).
• Use only a source of AC power that complies with local building and electrical codes and has both
overload and ground-fault (earth-fault) protection.
• Use only a power input cable that is rated 20 A, hard usage type and heat-resistant to 90° C (194° F)
minimum. The cable must have three conductors and an outer diameter of 5 - 15 mm (0.2 - 0.6 in.). In
North America the cable must be 12 AWG minimum conductor size, SJT or better. In the EU the cable
must be 2.5 mm², HAR compliant.
• Do not attempt to bypass a thermostatic switch or fuse. Replace defective fuses only if authorized by
Martin™ and with Martin™ service documentation for the product. Replace fuses with the same type and
rating only.
• Before using the fixture, check that all power distribution equipment and cables are in perfect condition
and rated for the current requirements of all connected devices.
• Isolate the fixture from power immediately if the power cable or power plug are in any way damaged,
defective or wet, or if they show signs of overheating.
• Do not expose the fixture to rain or moisture.
• Refer any service operation not described in this manual to an authorized Martin Service partner.
WARNING!
product.
DANGER! Warning!
Hazardous Fire hazard.
voltage. Risk of
severe or lethal
electric shock.
Warning! Warning!
Burn hazard. Risk of eye
Hot surface. Do injury. Safety
not touch. glasses must
be worn.
Warning!
Risk of hand
injury. Safety
gloves must be
worn.