TracVision M9 User Manual page 54

6a. (Linear systems only) - Repeat Step 5 for each
polarization/band:
•Vertical High
•Vertical Low
6b. (Circular systems only) - Repeat Step 5 for each
polarization/band:
•Right
If your selected satellite does not have information for
one or more of these transponder categories, you can
enter the following defaults instead:
Transponder Data
Frequency
Symbol rate
FEC code
Network ID
7. Type ZAP then press Enter. The antenna restarts. Wait
one minute for system startup.
8. Refer to "Setting the MCU to Track Satellites" on
page 19 to select your new user-defined satellite(s) for
tracking from the satellite library. Be sure use the
following installation names for your user-defined
satellite(s):
Satellite
User-defined Satellite 1
User-defined Satellite 2
TracVision M9 User's Guide
Appendix B - Programming User-defined Satellites
• Horizontal High
• Horizontal Low
• Left
Default Value
00000
27500
Same value as other transponders
with valid data
0x0000
Installation Name
USER1
USER2
59