TracVision M9 User Manual page 39

TracVision M9 User's Guide
Chapter 4 - Troubleshooting
Loose RF Connectors
Type of Multiswitch Used
Cable Unwrap
40
KVH recommends periodically checking the antenna unit's cable
connections. A loose RF connector can reduce signal quality or prevent
automatic satellite switching using the receiver's remote control. Refer
to the TracVision M9 Installation Guide for complete system wiring
information or visit any KVH-authorized dealer or distributor for
assistance. To find a KVH-authorized dealer near you, visit
www.kvh.com/wheretogetservice.
If your TracVision system's configuration requires a multiswitch, an
active (powered) multiswitch must be used to ensure proper antenna
performance. Receiver wiring diagrams are provided in
"Appendix C" on page
If your vessel makes several consecutive circles in the same direction,
the antenna will rotate 720° before reaching the end of its internal
cable. If this occurs, the system will automatically unwrap the cable by
quickly rotating the antenna dish in the opposite direction. During this
time, your TV picture will freeze momentarily.
63.