Manually Setting Latitude And Longitude - TracVision M9 User Manual

Manually Setting Latitude and Longitude

If the GPS is blocked or unavailable, you can manually set the vessel's
latitude and longitude data. Manually set latitude and longitude
values are automatically overwritten once valid GPS is detected.
Use the flowchart in
and longitude.
TIP: If the "Lat/Long not valid for Sat Pair" message appears, recheck and re-
enter your installed satellites.
Figure 3-8 Manually Setting the Latitude and Longitude
Tracking Satellite A
Sat B
Install Satellite?
Yes
Operations Mode?
Yes
Get Antenna Status?
Yes
Control Antenna?
Yes
Man Control Antenna?
Yes
Set Lat/Long?
Yes
Latitude:
–
Longitude:
–
Latitude:
Longitude:
Figure 3-8 if you wish to manually set the latitude
Menu Sat C
Next Return
Select "Next" until
"Operations Mode?"
is displayed.
Next Return
Next Return
Next Return
Next Return
Select "Next" until
"Set Lat/Long?"
is displayed.
Next Return
99N
Select "–" or "+"
Enter +
to change the
value. Then
select "Enter."
999W
Enter +
99N
999W
TracVision M9 User's Guide
Chapter 3 - Settings
31