Configuring Satellite Settings - TracVision M9 User Manual

TracVision M9 User's Guide
Chapter 3 - Settings

Configuring Satellite Settings

26
If a satellite's parameters are changed to use different parameters than
those stored in the TracVision system, you can use the flowchart in
Figure 3-3 to configure one of the satellites selected for tracking.
TIP: Circular satellites use the following polarization/band combinations:
right (RHC) and left (LHC). Linear satellites use the following polarization/
band combinations: vertical high (VH), vertical low (VL), horizontal high
(HH), and horizontal low (HL).
TIP: You can find satellite information on the web at
website is not affiliated with KVH).
Figure 3-3 Configuring Satellite Settings
Tracking Satellite A
Sat B Menu Sat C
Install Satellite?
Yes Next Return
Operations Mode?
Yes Next Return
Get Antenna Status?
Yes Next Return
Control Antenna?
Yes Next Return
Man Control Antenna?
Yes Next Return
Configure Satellite?
Yes Next Return
Configure Satellite
Sat A Sat B Sat C
Configure Satname1?
Yes Next Return
Polarization: XXX
– Enter +
Configure Frequency?
Yes
Set Freq: XXXXXMHz
Select "Next"
–
until "Operations
Mode?" is
displayed. Configure Symbol Rate?
Yes
Sym Rate: XXXXXM/S
–
Configure FEC Code?
Yes
Select "Next"
–
until "Configure
Satellite?" is
Configure Network ID?
displayed.
Yes
Select which
Set ID: XXXXXXXXHEX
satellite to
–
configure.
Select "–" or "+"
to change the
value of each
parameter. Then
select "Enter."
www.lyngsat.com (this
Next Cancel
Enter +
Next Cancel
Enter +
Next Cancel
FEC Code: X/X
Enter +
Next Cancel
Enter +