Cybex 600T Treadmill Owner's Manual
Quick Start
Press the Quick Start key. After a 3-second countdown, the running belt will
start at 1 mph (1.6 kph) in the Manual program. Use the
change speed and elevation.
NOTE: For an accurate calorie count, you must correctly set your weight
(including clothing) by pressing the Weight key.
Stopping the Treadmill
Press Pause/Stop to temporarily stop your workout. The belt will stop, but any
elevation will remain, as will all workout settings and data. Press the Quick
Start key to continue your workout. If no key has been pressed after the
amount of time set for Idle Time, usually 30 seconds, workout data will be
cleared, the display will change to Dormant Mode, and any elevation will be
reduced to zero. See Figure 1.
If, during a pause, the Pause/Stop key is pressed again, all workout data will
be cleared and elevation reduced to zero.
Figure 1
Automatic Stop Feature
The 600T is equipped with an Automatic Stop system for the running belt. If
the treadmill detects that there is nobody running or walking on it, it will stop
the belt after a user-selectable delay. (Set this delay time, called Halt Time, in
the Setting Operations Options section in chapter 5.)
3 - Operation
and
arrows to
Front Pages
About This Manual . . . . . . . . . . i
FCC Compliance Information . i
Declaration of Conformity . . . . ii
Table of Contents . . . . . . . . . . iii
1
Safety
Important Voltage Information 1-1
Grounding Instructions . . . . 1-1
Important Safety Instructions 1-2
Warning Labels . . . . . . . . . . 1-4
Caution Labels. . . . . . . . . . . 1-5
2
Technical Specifications
Specifications . . . . . . . . . . . 2-1
Stableflex System . . . . . . . . 2-2
3
Operation
Quick Start. . . . . . . . . . . . . . 3-1
Stopping the Treadmill. . . . . 3-1
Automatic Stop Feature . . . 3-1
Selecting Programs &
Options . . . . . . . . . . . . . . . . 3-2
Displaying Heart Rate . . . . . 3-2
The Workout Graph . . . . . . . 3-2
Detailed Operation Guide . . 3-3
Control During Operation . . 3-4
Changing Data Readouts . . 3-5
Use of Programs . . . . . . . . . 3-6
4
Preventive Maintenance
Regular Maintenance
Activities . . . . . . . . . . . . . . . . 4-1
Running Belt Maintenance . 4-3
5
Setup & Assembly
Quick Setup . . . . . . . . . . . . 5-1
Choosing & Preparing a Site 5-1
Electrical Power
Requirements . . . . . . . . . . . . 5-3
Unpacking . . . . . . . . . . . . . . 5-3
Assembling the Treadmill. . . 5-4
Test the 600T Operation . . . 5-8
Setting Operation Options. . 5-9
6
Customer Service
Contacting Service . . . . . . . 6-1
Serial Number & Voltage . . . 6-1
Warranty . . . . . . . . . . . . . . . 6-1
Return Material Authorization
(RMA). . . . . . . . . . . . . . . . . . 6-4
Damaged Treadmill or Parts 6-4
Ordering Parts . . . . . . . . . . . 6-5
Page 3-1