Test The 600T Operation - CYBEX 600T Owner's Manual

F. Fasten the back console with the screws removed during step 11A. NOTE: The two
gold screws are for the accessory holder.
! WARNING: Be sure that all electrical requirements are met as indicated in the

Test the 600T Operation

Use the following instructions to test the full speed and incline range of the treadmill and to
check the belt for proper operation.
1. Locate the on/off (I/O) power switch on the front side of the treadmill. Toggle it to the on
position (I).
2. The control panel will light up and be in the Dormant Mode.
NOTE: Cybex recommends that the treadmill be unplugged or the on/off (I/O) power
3. Press the Quick Start key. The treadmill begins a countdown (3,2,1), and sounds a tone
for each count. After it reaches one (1), the treadmill gives a steady tone, and then begins
accelerating the belt to reach 1 mph (1.6 kph).
4. The bottom left display will flash the time of and the right display will show the actual
speed.
5. Press and hold down the Speed
approximately 4 mph (6.4 kph), as indicated on the display.
6. Observe the belt to see that it is running properly; it should stay centered in the middle of
the deck. If you have problems with the running belt operation, see Running Belt
Maintenance.
7. Run the treadmill through its full speed range. First press the Speed
treadmill reaches its highest speed, 10 mph (16.1 kph). Then press the Speed
the treadmill is back to 1.0 mph (1.6 kph).
Page 5-8
Cybex 600T Treadmill Owner's Manual
specifications at the front of the manual and at the beginning of this
chapter prior to proceeding.
switch turned off (O) when it is not in use.
key until the treadmill reaches a speed of
key until the
key until