Table of Contents
Advertisement
8. Attach the junction covers.
A. Place the set of junction covers with the bottle holder over the right handlebar to
upright junction and secure them with four Phillips head screws provided in bag 2. See
Figure 5.
B. Place the remaining set over the left handlebar to upright junction. Secure them with
four Phillips head screws provided in bag 2. See Figure 5.
Figure 5
9. Attach emergency stop key.
A. Remove the paper backing from the velcro on the
emergency stop key clip. Place the sticky back to one
side on the accessory holder.
B. Confirm that the emergency stop key is in place. See
Figure 6. NOTE: the treadmill will not run without it in
place. Your treadmill should now look like Figure 7.
10. Level your treadmill.
A. Check to see if the treadmill is level. Perform steps 10B - 10D if the treadmill is not
level.
B. Loosen the (top) jam nut located on the right foot. See Figure 7.
C. Raise or lower the (bottom) leveling nut until the treadmill is level. See Figure 7.
D. When level, tighten the (top) jam nut upward until it is snug against the top.
Page 5-6
Cybex 600T Treadmill Owner's Manual
Junction
Covers
Bottle
Holder
Figure 6
Advertisement
Table of Contents
