Table of Contents
Advertisement
MAINTENANCE WORK ON CHASSIS AND ENGINE
–
Mount the wheel spindle but do not push it in all the way.
–
Push the rear wheel forward as far as possible and lay the chain on the rear sprocket.
–
Push the wheel spindle in all the way and mount chain adjuster
Info
Mount chain adjuster
–
Push the rear wheel forward so that the chain adjusters are in contact with the adjust-
ing screws, and tighten nut
100636-10
Guideline
In order for the rear wheel to be correctly aligned, the markings on the left and right
chain adjusters must be in the same position relative to the reference marks
Nut, rear wheel spindle
(990 Adventure)
–
Insert wheel speed sensor
Guideline
Screw, wheel speed sen-
sor, rear
–
Operate the foot brake lever repeatedly until the brake linings lie on the brake disc and
there is a pressure point.
–
Raise the vehicle off of the center stand. (
100635-11
and
in the same position.
.
M25x1.5
90 Nm
(66.4 lbf ft)
into the hole. Mount and tighten screw
M6
8 Nm
(5.9 lbf ft)
p. 67)
104
and nut
.
.
Thread greased
.
Loctite
®
243™
Advertisement
Table of Contents
